Energy by floor and tenant
Meter readings sit beside the plant that serves each floor, so waste is easy to locate.
Solution
Commercial Buildings
Offices, malls and mixed-use towers run chillers on BACnet, tenant meters on Modbus and lighting on KNX. IoTServa reads them where they are and puts them in one hierarchy.
- BACnet
- Modbus
- KNX
The Problem on Site
Each trade installed its own system, so facilities teams swap between consoles to answer simple questions: which floor is wasting energy, which air handler is hunting, which tenant meter went silent. Nothing joins the data together.
Typical Equipment
- Chillers, AHUs and VAV controllers
- Main and tenant energy meters
- Lighting and blind controllers
- Lift and pump status contacts
- Water and gas meters
What You Get to See
Comfort and faults together
Zone temperatures and equipment alarms trend side by side instead of in separate tools.
One alert path
Alerts from any protocol reach the same on-call list with the same wording.
Reports without exports
Building and tenant summaries come from one history, not from stitched spreadsheets.
Protocols in This Setup
Each one is read natively and joins the same tag model.
BACnet
Read chillers, air handlers and VAV boxes over BACnet/IP and BACnet MS/TP, with COV subscriptions so changes arrive when they happen.
Read MoreModbus
Poll Modbus RTU and Modbus TCP devices, decode registers with the right word order and scaling, and publish clean engineering values.
Read MoreKNX
Listen to KNX group telegrams over KNX IP, map group addresses from your ETS project, and control rooms from one place.
Read MoreWhere We Suggest the Pilot Starts
Start with the plant room BACnet points and the main incoming meter. Add one floor of tenant meters once those read cleanly.
Questions for This Setup
Do we have to replace our BMS?
No. IoTServa reads from the BMS controllers and the meters beneath it, and leaves control logic where it is.
Can we keep our existing BACnet integrator?
Yes. IoTServa is a read-first layer beside the existing BMS and does not take over its configuration.
Show Us the Commercial Buildings Equipment. We Will Scope the Pilot.
Tell us which protocols are on site. We will scope a pilot that reads your real devices.